Gear Protection Spray

The Gear Protection Spray forms a lubricating and protective layer on open gears, gear rims, racks and pinions. Open gear teeth run without an oil bath and are exposed to dust, moisture and weather; the sprayed-on film does both jobs there: it lubricates the tooth flanks in mesh and protects the metal surface between operating phases.

As a lubricant spray for gear teeth, the product is applied in the installed state and spreads over the tooth flanks as the gear is turned. The film adheres to the gear and stays in place instead of being flung off during rotation. This reduces relubrication intervals and keeps the area around the gear unit clean.

The Gear Protection Spray is aimed at maintenance, conveyor technology, crane and lifting technology, agricultural machinery, construction machinery service and plant construction, as well as the technical trade. The product is not intended for enclosed gear units with an oil filling; there, the gear unit manufacturer's specifications apply.

1. Clean the gear teeth and remove old lubricant residues and abrasion.
2. Shake the can vigorously and secure the gear unit against unintentional start-up.
3. Apply the spray evenly to the tooth flanks and turn the gear slowly.
4. Allow the film to set before the gear unit runs under load.
5. Check the condition of the film during maintenance rounds and relubricate if required.

The information on the label and in the safety data sheet is authoritative.